![]() SPI Serial flash detected 0xf8000000, 4096KB (64sec x 64KB) physmap platform flash device: 00400000 at f8000000 ata2: SATA link down (SStatus 0 SControl F300) Delay 5 seconds to wait for disk 2 ready. ata1: SATA link down (SStatus 0 SControl F300) Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled io scheduler anticipatory registered (default) Block layer SCSI generic (bsg) driver version 0.4 loaded (major 254) alg: No test for des3_ede (des3_ede-generic) Dquot-cache hash table entries: 1024 (orbytes) Trying to unpack rootfs image as initramfs. RPC: Registered tcp NFSv4.1 backchannel transport module. TCP: Hash tables configured (established 8192 bind 8192) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP established hash table entries: 8192 (order: 4, 65536 bytes) IP route cache hash table entries: 2048 (order: 1, 8192 bytes) raid6: using algorithm int32x8 (146 MB/s) PCI: bus0: Fast back to back transfers enabled Feroceon L2: Cache support initialised, in WT override mode. xor: using function: arm4regs (1086.000 MB/sec) Memory: 244992KB available (3656K code, 519K data, 124K init, 0K highmem) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) PID hash table entries: 1024 (order: 0, 4096 bytes) Kernel command line: console=ttyS0,115200 ip=off initrd=0x00800040,4M root=/dev/md0 rw syno_hw_version=DS212j ihd_num=2 netif_num=1 Built 1 zonelists in Zone order, mobility grouping off. ![]() Memory policy: ECC disabled, Data cache writeback Using UBoot passing parameters structure CPU: VIVT data cache, VIVT instruction cache The kernel will try to load, but I get this: I'm at a point where I can transfer files to the unit via TFTP. I just need to get the files in the right places now.ĮDIT: I am not a pro when it comes to this stuff, so if I'm using incorrect terminology, please forgive me. Does someone have a 212j they've accessed via serial, or have the ability to access that wouldn't mind sending over what they can? I have the files. I think my problem is I don't know the correct addresses for zimage, uboot, etc. I get a marvell prompt and I've been making progress. I've gotten into the serial interface on a used DS212j I acquired.
0 Comments
Leave a Reply. |